This page is experimental and may change significantly in future releases.
OT Program Mode Command
Properties
- name
- OT Program Mode Command
- definition
- Command that places the controller in a mode capable of reprogramming logic. This may or may not stop the program.
- comment
- GE-SRTP: SET PLC (RUN VS STOP)
- comment
- BACnet: deviceCommunicationControl BACnet: reinitializeDevice
- see also
- https://modbus.org/docs/Modbus_Application_Protocol_V1_1b3.pdf
- see also
- https://nvlpubs.nist.gov/nistpubs/TechnicalNotes/NIST.TN.2023.pdf
- see also
- https://icscsi.org/library/Documents/ICS_Protocols/Control%20Microsystems%20-%20DNP3%20User%20and%20Reference%20Manual.pdf
Neighbors