Malicious Use of Hardware Commands - EX-0005.02

Threat actors may issue low-level device or maintenance commands that act directly on hardware, bypassing much of the high-level command mediation. These may be memory-mapped register writes forwarded over the bus, vendor-specific instrument/control opcodes, built-in-test and calibration modes, boot-mode or fuse-programming sequences, file/sector operations to on-board non-volatile stores, or actuator primitives for wheels, thrusters, motors, heaters, and RF chains. Because these interfaces exist to configure sensors, zero momentum, switch power domains, tune gains, or adjust clocks, they can also be sequenced to produce harmful effects: over-driving mechanisms, altering persistent calibration, disabling watchdogs, or switching timing sources. Some hardware command sets are only exposed in maintenance or contingency modes, while others are always reachable through gateway processors that translate high-level telecommands into device-level operations. By crafting orders that respect expected framing and rate/size limits, the adversary can induce mechanical, electrical, or logical state changes with immediate, high-privilege impact, all while appearing to exercise legitimate device capabilities.